Picking the Right Heat for Your Bathroom
We build our infrared heaters with an IP65 rating. In plain English? They’re built for the steam and splashes of a bathroom without shorting out the second things get damp. But here is the thing: bigger isn’t always better. You don’t need the most powerful heater on the market; you just need the one that fits your room. If you overdo it, you’re just throwing money away on your electric bill and making the room feel like a sauna. Getting the wattage right Shortwave infrared is different because it warms you up, not the air around you. If you’ve got a tiny powder room, a 400W to 600W lamp is plenty. I’ve seen people put 1000W units in these small spaces, and it’s a mistake. The room gets hot way too fast, the thermostat kicks off, then kicks back on. That constant cycling just wears out the lamp. For a medium bathroom, go with a single 800W-1200W unit or maybe two smaller lamps. If you’re dealing with a massive master bath, don’t just buy one giant heater. You’ll end up with one scorching hot spot and freezing cold corners. Instead, spread out a few 600W points to get a nice, even glow everywhere. The technical bit (don’t skip this) That IP65 seal comes from reinforced gaskets and tight cable entries. It keeps the gunk out. But before you wire everything up, check your breaker. A 1200W lamp pulls a lot more power than a standard light bulb. If you’re swapping out an old fixture, make sure your wiring can actually handle the load so you don’t trip the power the moment you turn it on. Comfort vs. Raw Power There’s a big difference between “hot” and “comfortable.” When you crank up the wattage too high in one spot, you get a harsh heat. You’ll feel it burning your skin on one side while your back is still shivering. It’s an unpleasant feeling. If you split that same amount of power across two smaller lamps, the heat spreads out. It feels softer. More natural. You get the same amount of warmth, but it actually feels good.